Sony VPL-VW6 Operating Instructions Manual page 55

Symptom Cause and Remedy
The picture flickers.
~ Activate "APA", then adjust the current input signal.
~
Adjust "Phase" for "Adjust Signal" in the Screen
ED
menu
properly.
(C1r
page 45)
The color of characters or
~ Select the desired color registration in "Panel Alignment" of
the picture is not
Installation
~
menu
(C1r
page 51).
appropriate.
On-screen display
Symptom Cause and Remedy
On-screen display does not
~
Set "Status" in the Setup
;II
menu to "On."
(C1r
page 46)
appear.
~ Check if the
1/(9
(ON/STANDBY) indicator should light in
green.
The model name does not
~
The display mode of the projector may be set at the time of
disappear from the screen. purchase. Consult with your local dealer or qualified Sony
personnel.
Remote control
Symptom Cause and Remedy
The remote control does
~
Batteries could be weak. Replace them with new batteries.
not work.
(C1r
page 11)
~ Insert the batteries with the correct polarities.
(C1r
page 11)
~ In the Installation ~ menu, set the setting of "IR Receiver" to
"Front
&
Rear".
(C1r
page 50)
~
If there is a fluorescent lamp near the remote control detector, the
projector may work improperly or inadvertently. Change the
setting of "IR Receiver" in the Installation
~
menu.
(C1r
page 50)
Others
Symptom Cause and Remedy
The fan is noisy.
~
Check the setting of "Cooling Setting" in the Setup
;II
menu.
(C1r
page 46)
~
Make sure that the room temperature is not too high.
Check the installation conditions.
(C1r
page 12)
The number of fan rotation increases to maintain the product
reliability of the projector's components in a room, where the
temperature is higher than normal. The fan noise becomes
slightly louder. The approximate normal temperature is 25°C.
55
o
-
~
<D
en