DeWalt D23620-XE Instruction Manual page 8

FIG. 2
I
M
L
FIG. 3
B
A
N
F
E
8
FIG. 4
E
Depth of cut adjustment (Fig. 2, 3)
1. Loosen the depth adjustment knob (L).
2. Move the shoe (E) to obtain the correct depth of cut.
3. Tighten the depth adjustment knob (L).
WARNING: For optimal results, allow the saw blade to protrude from the workpiece
by about 3 mm (see inset in Figure 3).
Bevel adjustment (Fig. 4)
The bevel angle can be adjusted between 0° and 50°.
1. Loosen the bevel adjustment knob (I).
2. Set the bevel angle by tilting the saw shoe (E) until the mark indicates the desired
angle on the scale.
3. Tighten the bevel adjustment knob (I).
Shoe adjustment for 90° cuts (Fig. 2)
1. Adjust the saw to 0° bevel.
2. Retract the blade guard using the lever (F) and place the saw on the blade side.
I