Table of Contents
Advertisement
GETTING UP AND RUNNING
Attaching the hand strap
Always keep the strap around your wrist in the event that the camera is
accidentally dropped.
Pass the small loop of the hand strap through
the strap eyelet on the camera body (1).
1
2
10
G
ETTING UP AND RUNNING
Pass the other end of the strap
through the small loop and tighten
(2).
Installing batteries
This digital camera uses two AA-size Ni-MH batteries or one CR-V3
lithium battery. When using Ni-MH batteries, fully recharge them with a
battery charger suitable for complex electronic equipment. Although
alkaline batteries can be used, their performance is very low and is not
recommended for normal use. Do not use other types of AA batteries.
When replacing the batteries, the camera should be turned off.
Open the battery-chamber door on the
2
bottom of the camera by sliding the door
toward the side of the camera (1) to release
the safety catch; the door can then be
opened (2).
1
Insert the batteries as shown.
Never force the battery.
3
Close the battery-chamber door (3) and
4
slide it toward the body (4) to engage the
safety catch.
AA-size
batteries
CR-V3 lithium battery
(Continued on the next page)
11
Advertisement
Table of Contents
