Disconnecting The Camera From The Computer - Minolta DiMage E223 Instruction Manual

Disconnecting the camera from the computer

Follow the instruction below when disconnecting the camera from the
computer. This procedure is also necessary before changing the memory
type while the camera is connected to the computer. The appearance of
screens may differ with the operating system.
Never disconnect the camera when the indicator lamp is blinking
- the data or memory card may permanently be damaged.
Windows 98 / 98 Second Edition
Confirm that the green indicator lamp is not blinking. Turn the camera off
and then disconnect the USB cable.
Windows Me, 2000 Professional, and XP
To disconnect the camera, click once on the unplug-or-eject-
hardware icon located on the task bar. A small window will
open indicating the device to be stopped.
Click on the small
window to stop the
device. The safe-to-
remove-hardware
window will open. Close
the window, turn the
camera off, and then disconnect the USB cable.
When more than one external device are connected to the computer,
repeat the procedure above except right click on the unplug-or-eject-
hardware icon. This will open the unplug-or-eject-hardware window after
clicking on the small window indicating the unplug-or-eject-hardware
routine.
54 D
ATA TRANSFER MODE
The hardware devices to be
stopped will be displayed.
Highlight the device by
clicking on it then click "Stop."
A confirmation
screen will appear to
indicate the devices
to be stopped.
Clicking "OK" will
stop the device.
A third and final screen
will appear to indicate
the camera can be
safely disconnected
from the computer.
Close the window, turn
the camera off, and then disconnect the USB cable.
Macintosh
Confirm that the green indicator
lamp is not blinking and then drag
the mass-storage device icon and
drop it into the trash. Turn the
camera off, and then disconnect the
USB cable.
55