Table of Contents
Advertisement
2
Select [<] and press
• To remove all pictures from the print order, select [Reset] and press
To exit without removing all pictures, select [Keep] and press
Press HI to select images you wish to remove from the print order.
3
• Use G to set the number of prints to 0. Press
desired pictures from the print order.
4
Select the date and time format and press
• This setting is applied to all frames with print reservation data.
5
Select [Set] and press
Direct printing (PictBridge)
By connecting the camera to a PictBridge-compatible printer with the USB cable, you
can print out recorded pictures directly.
1
Connect the camera to the printer using the supplied USB cable and turn
the camera on.
USB port
• Use a fully charged battery for printing.
• When the camera is turned on, a dialog should be displayed in the monitor prompting
you to choose a host. If it is not, select [Auto] for [USB Mode] (P. 93) in the camera
custom menus.
Use FG to select [Print].
2
• [One Moment] will be displayed, followed by a print-
mode selection dialog.
• If the screen is not displayed after a few minutes,
disconnect the USB cable and start again from Step 1.
Proceed to "Custom printing" (P. 114).
#
Cautions
• 3D photos, RAW images, and movies cannot be printed.
.
.
.
Multi-connector
Smaller terminal
USB cable
.
.
once you have removed all the
USB
Storage
MTP
Print
Exit
8
Set
113
Advertisement
Table of Contents
