Removing The Mower - Toro 74629 Operator's Manual

1
1. Adjusting rod
2. Adjusting block
7. To raise the front of the mower, tighten the adjustment
nut.
8. To lower the front of the mower, loosen the adjustment
nut.
9. After adjustment, check the front-to-rear slope again,
continue adjusting the nut until the front blade tip is
1.6 to 7.9 mm (1/16 to 5/16 inch) lower than the rear
blade tip (Figure 53).
10. When the front-to-rear blade slope is correct check
the side-to-side level of the mower again; refer to
Side-to-Side Leveling (page 35).

Removing the Mower

1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3. Lower the height-of-cut lever to the lowest position.
4. Remove the hairpin cotter from the front support rod,
and remove the rod from the deck bracket (Figure
55). Carefully lower the front of the mower deck to
the ground.
3
2
G014634
Figure 54
3. Locknut
3
1. Front support rod
2. Locking nut
5. Lift the mower deck and hanger brackets clear of the
rear lift rod, and lower the mower carefully to the
ground (Figure 56).
2 2
1
1. Mower deck
2. Hanger bracket
6. Slide the mower deck rearward to remove the mower
belt from the engine pulley.
7. Slide the mower deck out from underneath the
machine.
Note: Retain all parts for future installation.
37
2
1
G014635
Figure 55
3. Deck bracket
2 2
3 3
G015338
Figure 56
3. Rear lift rod