Side Grip (Auxiliary Handle); Bit Grease; Installing Or Removing The Bit; Bit Angle - Makita HR2470 Instruction Manual

Side grip (auxiliary handle)

1
3
5
4
2
007949
CAUTION:
Always use the side grip to ensure operating
•
safety.
Install the side grip so that the teeth on the grip fit in
between the protrusions on the tool barrel. Then tighten
the grip by turning clockwise at the desired position. It
may be swung 360° so as to be secured at any position.

Bit grease

Coat the bit shank head beforehand with a small amount
of bit grease (about 0.5 - 1 g).
This chuck lubrication assures smooth action and longer
service life.

Installing or removing the bit

2
1
003150
Clean the bit shank and apply bit grease before installing
the bit.
1
2
007938
Insert the bit into the tool. Turn the bit and push it in until
it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
1. Grip base
6
2. Side grip
3. Loosen
4. Tighten
5. Teeth
6. Protrusion
1. Bit shank
2. Bit grease
1. Bit
2. Chuck cover
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
1
2
007939
Bit angle (when chipping, scaling or
demolishing)
2
007950
The bit can be secured at the desired angle. To change
the bit angle, depress the lock button and rotate the
action mode changing knob to the O symbol. Turn the bit
to the desired angle.
Depress the lock button and rotate the action mode
changing knob to the
bit is securely held in place by turning it slightly.
007951

Depth gauge

1
007952
7
1. Bit
2. Chuck cover
1. Lock button
1
2. Action mode
changing knob
symbol. Then make sure that the
1. Depth gauge