4. Getting started
Insert batteries into remote control unit
The battery compartment is situated at the rear of the re-
mote control unit.
1. Open the battery compartment by pushing the covering
bracket a bit down and lifting the battery compartment lid.
2. Insert the batteries as shown on the bottom of the battery
compartment. Observe the polarity!
3. Close the battery compartment again. The battery compart-
ment lid is to engage audibly.
Connecting the receiver
Note:
Observe the operating instructions of the other devices as
well as the graphic connection diagram, see page 23.
Make sure all appliances are turned off before connecting
them. First establish all other connections, then plug the
power supply connector into the mains socket. This is to avoid
possible damage.
20
Attention!
GETTING STARTED