Service Adjustments - Sanyo CP32WF2 Service Manual

Service Adjustments

Note: Some items of the service adjustments for this chassis are controlled by the CPU (IC801), and the
adjustments are carried out by using the RC handset.
After replacing the Memory IC (IC803)
The memory IC (IC803), stores the service adjustment data for each circuit, therefore, when the memory IC is
replaced, it should be programmed by using "OPTION SETTING" on previous page and the following adjustment.
Adjustable Service Adjustment
Regular
Item No.
01
02
03
04
05
06
08
Image
Item No.
01
02
03
04
05
06
07
08
11
12
13
Important Notice:
Do not attempt to adjust service adjustments not listed on above otherwise it may cause loss of performance and
product safety.
OSD
AGC
--
GRY
GRY
CTR
--
OSD
OSD
P V-C
P H-P
P V-L
P VSC
P V-A
P H-S
P E-P
P E-T
P ECT
P ECB
P HPA
Description
AGC Adjustment
Cut-Off Drive Adjustment
G-Drive Adjustment (White Balance)
B-Drive Adjustment (White Balance)
Contrast Adjustment (use factory setting) (for factory use)
Screen Adjustment mode
OSD Positioning Adjustment
Description
P Vertical Position Adjustment
P Horizontal Position Adjustment
P Vertical Linearity Adjustment
P Vertical S-Correction Adjustment
P Vertical Size Adjustment
P Horizontal Size Adjustment
P Pin Cushion Adjustment
P Trapezoid Distortion Adjustment
P Top Corner Correction Adjustment
P Bottom Corner Correction Adjustment
P Parallelogram Distortion Adjustment
-9-