sunjoe MJ407E Operator's Manual page 8

1 2
5. To re-install the blade, position the blade with the
cutting edges toward the ground. Assemble the blade,
the square washer, and the blade nut as shown in the
following. Using a 15-mm wrench or socket, turn the
blade nut "CLOCKWISE" to secure the blade.
NOTE:
Be sure to replace the parts in the exact order in
which they were removed. When installing the cutting blade,
verify that it is installed with the curved ends pointing toward
the mower deck.
Fig. 10
Tighten
Fig. 9
3
Loosen
Clean the Mower
m
WARNING:
To reduce the risk of electric shock, do not
expose the mower to water.
The underside of mower deck should be cleaned after each
use as grass clippings, leaves, dirt and other debris will
accumulate causing rust and corrosion.
Remove any buildup of grass and leaves on or around the
motor cover (do not use water). Wipe the mower clean with a
dry cloth occasionally.
• If debris build up on the underside of the unit while using,
stop the motor and disconnect it from the power supply.
Tilt the mower forward, or on its side, and scrape it clean
with an appropriate tool.
Storage
The following steps should be taken to prepare the lawn
mower for storage.
• Make certain the power is disconnected.
• Clean mower as instructed in previous section.
• Inspect and replace/sharpen blade, if required. Refer to
the Maintenance section.
• Store mower in a dry, clean area. Do not store next to
corrosive materials, such as fertilizer and rock salt.
• Wipe extension cord to remove any foreign substances
such as oil or stains. Replace extension cord if cut or
damaged in any way.
• Wind the cord in a series of equal loops to prevent it
from tangling.
• Store mower indoors, in a cool, dry place, out of reach
of children. Do not cover lawn mower with a solid plastic
sheet. Plastic coverings trap moisture around the mower
causing corrosion.
• The handle may be folded away completely for storage.
• Loosen the handle knobs on the sides of the handle, and
fold the upper handle down.
• Loosen the handle knobs, pull outwards on each side of
the lower handle, and lift the sides of the lower handle past
the edges of the handle mounting brackets. Fold the lower
handle forward. Make sure not to bend or kink the power
cord.
8
Meijer.com