Electrolux R600a Service Manual page 19

Thermal overload cut-outs
The two +10°C and +40°C thermal overload cut-
outs are connected together in one component E
and therefore are not available as single spare part.
They are fixed to the conveyor K with two screws.
Once the battery is unhooked, it can be folded, as
pictured, to access the heating elements, paying
attention to the pipes.
Stylus defrosting heater
The stylus defrosting heater G is fitted to the
battery by three clamps J; to replace it, remove the
clamps with a pliers (it is not necessary to cut them
because they can be used again).
19/22
R600a NOFROST REFRIGERATORS