Panasonic ES‑LV81 Operating Instructions Manual page 5

Charge
Charging using the self‑cleaning recharger
Thoroughly wipe off any drops of water on or around the self‑
cleaning recharger so that it is dry before charging the shaver.
1
1
Insert the appliance plug into
the self‑cleaning recharger.
2
2
Remove the protective cap and
then attach the shaver.
3
3
Plug in the AC adaptor into a
household outlet.
•
The "Charge" course starts when attaching the shaver.
•
Turn the shaver off before attaching.
•
Check that the outer foil is not deformed or damaged when you
are attaching the shaver.
•
Wipe off any water droplets on the main body rear terminal.
•
You can charge even with the STATUS lamp of the self‑cleaning
recharger blinking.
•
Charging is completed after approx. 1 hour.
You can keep the shaver attached to the self‑cleaning recharger,
or connected to the AC adaptor, when not using it to maintain full
battery capacity. You cannot overcharge the shaver.
ES-LV81_AUS.indb 5
Charging without the self‑cleaning recharger
You can also charge without the self‑cleaning recharger.
1
1
Insert the appliance plug into
the shaver.
2
2
Plug in the AC adaptor into a
household outlet.
2 3
1
You cannot operate the shaver while charging.
Reading the LCD panel when charging
The LCD panel shows the remaining battery capacity from 0% to
100%, in 10% increments.
While charging
The indicators glow.
•
After charging is completed, turning the power switch ON with
the shaver plugged in will cause Battery capacity and Charge
status to light up and then turn off after 5 seconds. This shows
that the shaver is fully charged.
2
1
After charging is completed
Battery capacity and Charge status
will light up and then turn off after 5
seconds.
2011/02/25
5
15:50:34