CDA vw120 Manual For Installation, Use And Maintenance page 10

5. The warming drawer is supplied with three metal filler strips with
self-adhesive backing. These strips should be attached to the
warming drawer to seal any gaps between the appliance and the
housing. Remove the protective foil from each strip and position
it as shown in fig. 2 so it is flush with the rear and side walls of the
housing, then attach to the warming drawer. If there is no rear wall
to the housing, the rear trim is not required.
The casing of this appliance will get hot. Ensure that any cables that
may come into contact with the appliance once installed are suitable
for use at 85°C.
Fig. 4
10
20-24
594
573
598
128
545
595
548
23
6
20-24
594
573
598
545
289
595
548
6
23
276