Table of Contents
Related Manuals for CDA vw150
Summary of Contents for CDA vw150
- Page 1 Warming Drawer Manual for Installation, Use and Maintenance Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu...
- Page 2 Keep children away from the appliance when in use, and immediately after use. Appliance information: Please enter the details on the appliance rating plate below for reference, to assist CDA Customer Care in the event of a fault with your appliance and to register your appliance for guarantee purposes.
- Page 3 Appliance Model Serial Number CE Declarations of Conformity: This oven has been designed, constructed and marketed in compliance with safety requirements of EEC Directive 2006/95/EEC (Low voltage) and requirements of EMC Directive 2004/108/EEC. This appliance has been manufactured to the strictest standards and complies with all applicable legislation, including Electrical safety (LVD) and Electromagnetic interference compatibility (EMC).
- Page 4 Important • Do not rest or sit on the drawer when open, as this will damage the telescopic runners. • The maximum capacity of the drawer is 25 kg. • Do not cover the bottom of the warming drawer with aluminium foil or other objects.
-
Page 5: Before First Use
Before First Use Cleaning Before using the warming drawer for the first time we recommend that you clean it with a damp cloth, then dry thoroughly. Preheat the empty drawer at maximum temperature for at least 2 hours. A slightly unpleasant smell may be produced, caused by grease remaining on the oven elements from the production process. - Page 6 • Place the dishes in the drawer. • Set the required temperature. • Press the power switch, which will light up to confirm the warming drawer is switched on. • Close the drawer gently. • Switch the appliance off before removing the warmed dishes. Selecting the Temperature •...
- Page 7 Warming Times The time necessary for warming depends on various factors: • Material and thickness of the dishes. • Quantity of dishes to be warmed. • Arrangement of dishes in the drawer. • Temperature setting. Therefore exact warming times cannot be provided. With use, experience will demonstrate optimal warming times and temperature settings.
- Page 8 Cleaning IMPORTANT: • Always disconnect the appliance from the power supply before undertaking any cleaning. • You should always allow the warming drawer to cool fully after use before undertaking any cleaning. • Never use high pressure water or steam cleaners. •...
- Page 9 Antislip drawer base • The antislip drawer base can be pulled out to clean the bottom of the drawer. The base can be washed by hand with hot water and a mild detergent. Dry thoroughly. Refit the antislip base in the drawer only when completely dry. Drawer base It is advisable to clean the bottom of the drawer after every use, making sure to allow it to cool.
-
Page 10: Troubleshooting
PLEASE NOTE: Steam cleaners must not be used to clean this appliance. Do not store flammable material in the warming drawer. Do not allow grease or food particles to build up around the door. IMPORTANT: When correctly installed, your product meets all safety requirements laid down for this type of product. -
Page 11: Installation
Installation Check the measurements on Fig.3 to confirm the requirements for your installation. Please note, the oven dimensions show a standard CDA oven and will vary 20-24 depending on the appliance being installed above the warming drawer. 1. Run the mains lead to the... -
Page 12: Mains Electricity Connection
may come into contact with the appliance once installed are suitable for use at 85°C. Mains Electricity Connection Warning! This appliance must be earthed We recommend that the appliance is connected by a qualified electrician, who is a member of the N.I.C.E.I.C. and who will comply with the I.E.T. - Page 13 1.5mm , HO5V2V2-F). • The current rating of the fuse or circuit breaker protecting this FUSE SPUR OUTLET appliance should be marked on the socket outlet (3A). • Assembly and electrical connection should be carried out by specialised personnel. • When installing this product we recommend you seek the help of USE A 3 AMP FUSE another individual.
- Page 14 Notes...
- Page 15 Notes...
- Page 16 Please contact our Customer Care Department for Service on the details below. Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu...