Advertisement

Quick Links

MBM Ideal 5009
Paper Shredder
Instruction Manual
Provided By
http://www.MyBinding.com
http://www.MyBindingBlog.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 5009 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for MBM 5009

  • Page 1 MBM Ideal 5009 Paper Shredder Instruction Manual Provided By http://www.MyBinding.com http://www.MyBindingBlog.com...
  • Page 2 IDEAL 5009-1 Operating Instructions IDEAL 5009-2 Modular conveyor belt system...
  • Page 3 IDEAL 5009-1 • IDEAL 5009-2...
  • Page 4: Table Of Contents

    Table of contents General ............4 1.1 Safety Instructions ........4 1.2 Application ........... 4 Installation ........... 5 2.1 Transport ............. 5 2.2 Preparing for installation ......6 Waste cart ........... 6 Conveyor belt (Accessory) ......6 2.3 Power supply ..........8 2.4 Checking rotating direction ......
  • Page 5: General

    IDEAL 5009-1 • IDEAL 5009-2 1. General This instruction manual is meant to help you to operate the machine easily and safely. Please read these operating instructions before putting the machine into operation and observe the safety regulations. 1.1 Safety Instructions...
  • Page 6: Installation

    2. Installation The machine is mobile on castors. The machine must be installed on a sturdy, dry and level floor. Danger! - The machine must not be used outside. - Do not use in the vicinity of flammable liquids or gases. - Do not use in wet environments.
  • Page 7: Preparing For Installation

    IDEAL 5009-1 • IDEAL 5009-2 2.2 Preparing for installation - Open the door. - Remove the transport safety device (1) and keep for later use. - Mount the supporting screws (3). - Screw down the supporting screws until the rear castors are balanced.
  • Page 8 - Remove the springs from the ball-ends (4) on both sides. - Dismount the tie-bar (5). - Push the slide to the back 31-01 - Push back the conveyor belt into the machine. - Turn both handles to lock. 33-01...
  • Page 9: Power Supply

    IDEAL 5009-1 • IDEAL 5009-2 2.3 Power supply The rating plate is located at the rear of the machine. - Data stated on the rating plate - Voltage “V“, - Frequency “Hz“, - Power consumption “A“ must correspond to the values of the power supply unit.
  • Page 10: Operation

    3. Operation Danger! - When the main switch is switched on do not use steps or anything similar when operating or repairing the machine. - The machine may only be operated by persons who have read and understood the operating instructions. - Do not reach into the running shredding mechanism! The shredding mechanism may cause serious injury!
  • Page 11: Stopping The Machine

    IDEAL 5009-1 • IDEAL 5009-2 When large amounts of paper are inserted the machine automatically adjusts to a more powerful, slower capacity. If this capacity is still not powerful enough the machine will reverse shortly and then return to the forwards mode. This is repeated until all material is completely destroyed.
  • Page 12: Replacing The Plastic Bag

    3.4 Replacing the plastic bag Replace bag when “bag full“ indicator illuminates. - Open the door (10). - Pull out the waste cart. - Remove the round belt (12) from the waste bag frame. - Pull the bag onto a pallet. - Tie the bag (for sealing parts and binding wires see accessories).
  • Page 13: Trouble Shooting

    IDEAL 5009-1 • IDEAL 5009-2 4. Trouble shooting Danger! Disconnect from the mains before starting any service work or before removing the cover. Malfunction: Standby (5) is not lighting up. Cause: - Main switch is OFF - Emergency button is pressed.
  • Page 14 Malfunction: Machine switches off during normal operation. Cause: Indicator for “bag full“ or “shred bag full“ illuminates. Remedy: Renew plastic bag. Cause: Yellow pilot light (7) illuminates, machine is overheated. Remedy: Wait approx. 10 to 20 minutes for the machine to cool down.
  • Page 15: Accessories

    IDEAL 5009-1 • IDEAL 5009-2 5. Accessories Plastic bags 350l (50 pieces) ....9000 414 Environmentally friendly oil 10 x 0,2 l ..9000 610 Module conveyor belt system (conveyor belt) ........9000 595 Pusher ........... 9000 593 For fastening plastic bags: 9000 595 Wire twisting tool ........
  • Page 16: Ec-Declaration Of Conformity

    - Hiermede verklaren wij, dat de in de handel gebrachte machine - Com a presente, declaramos que o modelo da - Hermed erklæres, at produkttypen 5009-1; 7050-1; 5009-2; 7050-2; - folgenden einschlägigen Bestimmungen entspricht: - complies with the following provisons applying to it:...
  • Page 17 IDEAL 5009-1 • IDEAL 5009-2 IDEAL Krug & Priester 72336 Balingen Germany www.ideal.de...

This manual is also suitable for:

Ideal 5009

Table of Contents