Cub Cadet LGTX1050 Operator's Manual page 18

Engaging the PTO
Engaging the PTO transfers power to the cutting deck or other
(separately available) attachments. To engage the PTO:
1. Move the throttle control lever to the FAST (rabbit)
position.
NOTE: When operating the tractor, be certain that the
throttle/choke control is always in the FAST (rabbit)
position. Operating with the throttle at less than full
throttle may lead to shortened battery life, and poor cut
quality.
2. Pull the PTO/Blade Engage knob outward into the engaged
(ON) position. See Figure 5-3.
ON
18 S 5 — o
ection peration
OFF
Figure 5-3
Mowing
WARNING!
To help avoid blade contact or a
thrown object injury, keep bystanders, helpers,
children and pets at least 75 feet from the machine
while it is in operation. Stop the machine if anyone
enters the area.
The following information will be helpful when using the cutting
deck with your tractor.
WARNING!
Plan your mowing pattern to avoid
discharge of materials toward roads, sidewalks,
bystanders and the like. Also, avoid discharging
material against a wall or obstruction which may
cause discharged material to ricochet back toward
the operator.
• Do not mow at high ground speed, especially if a mulch kit
or grass collector is installed.
• Do not cut the grass too short. Short grass is prone to weed
growth and yellows quickly in dry weather.
• Always operate the tractor with the throttle lever in the
FAST (rabbit) position while mowing.
IMPORTANT:
It is important to always operate the tractor with
the throttle in the FAST (rabbit) position to ensure proper charge
on the battery.
• For best results it is recommended that the first two laps be
cut with the discharge thrown towards the center. After the
first two laps, reverse the direction to throw the discharge
to the outside for the balance of cutting. This will give a
better appearance to the lawn.
• Do NOT attempt to mow heavy brush and weeds or
extremely tall grass. Your tractor is designed to mow lawns,
NOT clear brush.
• Keep the blades sharp and replace the blades when worn.