VDO MS 3100 Owner's Manual And Mounting Instructions page 49

Screwing the monitor support
Screw monitor support without mounting plate directly in place with two appropriate
screws.
Alternative mounting
To extend the mounting possibilities you can also mount the monitor without the
supplied support:
Directly stick the monitor on the dashboard with double-sided self-adhesive tape.
For alternative mounting different supports are available in the high street.
A
Observe safety warnings concerning driver's sight and airbag inflation area!
Installing holder for the remote control, ill. 10 - 11
Mounting on angle bracket
Screw holder to angle bracket. Either insert angle bracket into an available slot or
screw it in place.
Mounting with adhesive plate
Snap holder onto plastic plate. Remove protective paper from adhesive tape. Stick
holder with adhesive plate onto mounting surface and press firmly.
Completing electrical connections, ill. 12
Lay all cables carefully. Refer to the connecting diagram on the fold-out page at the
end of the booklet and to the table below.
Power supply cable 6 (ISO connector A):
Pin no. Cable colour
A1 black/white
A2 white/yellow
A3 white/brown
A4 red
A7 violet
A8 brown
A
Only connect electrical signals to appropriate terminals in the vehicle.
A
In the case of a direct connection to the battery secure the positive connection (red
lead) with a 10 A fuse close to the battery (approx. 10 - 15 cm).
1. Connect the free cable ends A4, A7 and A8 of the power supply cable 6 to suitable
terminals in the vehicle according to the connecting diagram and the table.
2. Do not cut off unused cables! Wind them together and tie them back! They may be
used later to install additional features.
Connection
speedometer signal input
back-up lights (reversing signal)
mute signal output (open collector)
+12V permanent power supply, "terminal 30" (via cable fuse 10 A if necessary)
+12V switched, "terminal 15" (must not be interrupted during engine start)
negative battery pole, "terminal 31"
MOUNTING INSTRUCTIONS
49