Table of Contents
Advertisement
MOUNTING INSTRUCTIONS
Insert metal sleeve into the DIN opening and press appropriate tags outwards with a
screwdriver. Take care not to damage hidden parts in the dashboard.
Alternative mounting, ill. 5
If the navigation computer should or can not be installed in a DIN opening, it can be
mounted in other places, for example in the glove compartment, in the luggage boot
or under the seats with the optional housing MA 2400. The supplied mounting
brackets allow you to equal bigger inclinations.
Installing GPS antenna, ill. 6 - 7
The GPS antenna can be mounted in the vehicle interior, for example on the
dashboard or on the hatshelf. The antenna must have clear "view" of the sky.
–
In vehicles with metallic window tinting the GPS antenna should be mounted
outside on the vehicle body, for example on the roof or in the plastic bumper.
–
On metal surfaces the antenna can be fixed magnetically. Therefor remove the
metal plate from the bottom of the antenna and place the antenna on the cleaned
surface.
–
When mounting on other surfaces the metal plate has to remain below the
antenna. In this case stick install antenna with double-sided adhesive tape.
Note: To ensure perfect function please keep a distance of at least 10 cm to metall
parts like window frame.
Mounting monitor, ill. 8
A
Never install the monitor in an area where the head could impact in case of an
accident!
The monitor can be fastened with the supplied support either in normal or in
suspended position. If it is mounted in suspended position, make sure that the display
contents is rotated 180 degrees ("System settings" menu, option "Display").
Glueing the support
1. Fix the mounting plate with two Phillips head screws to the bottom of the monitor
support.
2. Install monitor connector with the two countersunk screws to the monitor support,
see ill. 9.
3. Slide monitor on the connector until it clicks into position.
4. Determine the mounting position of the monitor.
5. Remove the monitor from the support.
CAUTION: When removing the monitor from the support, always make sure to press
the release key on the rear of the connector!
6. Clean the surface from grease and dust with methyl alcohol.
7. Remove protective paper from one side of the supplied adhesive tape and stick it to
the bottom of the mounting plate.
8. Remove protective paper from the lower side of the adhesive tape and place the
monitor support onto mounting surface and press firmly.
Note: Mounting temperature should be at least 15 degrees centigrade to ensure the
full adhesive effect of the tape.
48
Advertisement
Table of Contents
