Fuel System Maintenance; Replacing The In-Line Fuel Filter; Servicing The Emissions Filter - Toro SS 3200 Operator's Manual

Fuel System
Maintenance
DANGER
In certain conditions, gasoline is extremely
flammable and highly explosive. A fire or explosion
from gasoline can burn you and others and can
damage property.
• Perform any fuel related maintenance when the
engine is cold. Do this outdoors in an open area.
Wipe up any gasoline that spills.
• Never smoke when draining gasoline, and stay
away from an open flame or where a spark may
ignite the gasoline fumes.
Replacing the In-line Fuel
Filter
Service Interval: Every 100 hours—Replace the in-line
fuel filter
Never install a dirty filter if it is removed from the fuel
line.
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to the
park position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Raise the seat and locate the fuel filters as shown in
Figure 35.
1
2
3
1. Tee Fitting, vent line
2. Emissions filter
3. Open port
4. Fuel line from tank
4. Squeeze the ends of the hose clamps together and
slide them away from the filter (Figure 35).
5. Remove the filter from the fuel lines.
6. Install a new filter with the flow direction arrow
coming from the fuel tank and pointing to the
engine. Move the hose clamps close to the filter
(Figure 35) to secure it in place.

Servicing the Emissions Filter

Service Interval: Every 100 hours/Yearly (whichever
comes first)
The machine is equipped with a emissions filter
(Figure 35) connected to a tee fitting on the vent line
coming from the gas tank. The filter has an open port by
design. The filter should be inspected regularly. Replace
the filter if the filter is dirty or clogged.
30
G014689
4
5
8
7
Figure 35
5. In-line Fuel filter
6. Flow direction arrow
7. Fuel line to engine
8. Hose clamp
6