Connecting The Monitor - LG LCD Monitor User Manual

Connecting the Monitor

To set up the monitor, ensure that the power is turned off to the monitor,
computer system, and other attached devices, then follow these steps:
Place the monitor in a convenient, well-ventilated location near your computer.
1
Power off both the monitor and Computer.
2
Slightly press and pull the latch on Stand cover.
3
Connect the end of monitor signal cable to the connector
4
of your monitor throught the slot and cable holder on Stand. Connect the other
end to the 15-pin connector on the rear panel of the computer and tighten the
screws. Be sure the signal cable aligns with the 15-pin connector.
Connect the end of monitor signal cable to the connector
4'
of your monitor throught the slot and cable holder on Stand. Connect the other
end of the monitor signal cable to the rear panel of Macintosh computer
through a Macintosh adapter and then tighten screws.
Connect the plug from the AC adapter into the base of the monitor.
5
Connect one end of the AC power cord to the AC adapter
end to a properly grounded AC outlet that is easily accessible and close to the
monitor. 4
6 After connecting cables, put stand cover correctly into the holes unders stand.
If securely connected, you can hear click sound from the latch.
Power ON the PC, then the monitor.
7
If you see the NO SIGNAL message, check the signal cable and connectors.
8
After using the system, power OFF the monitor, then the PC.
9
IBM PC
MACINTOSH
D-15P
Mac Adapter
D-15P AC adapter
Signal Cable
* NOTE : If you see the "OUT OF
RANGE" message, check to make
sure your system is set to one of the
factory preset modes.(see page A9)
A2
1 at the rear panel
1 at the rear panel
3
and the other
Latch
2
Stand cover
1
4
3
Power Cord
2