Inserting Batteries; Remote Control Range; Adjusting The Clock - Sanyo DC-DA1465M Instruction Manual

Inserting batteries

Note:
Always remove battery if the remote control is not to be used for a month
or more. Battery within the unit may leak and cause damage.
1.
When the unit is fi rst connected to the AC power line, the display blinks
"00:00" dimly.
Example: To set "6:30".
First, press the z/ON button to turn the power on.
1. Press the PROGRAM/CLOCK button for at least 2 seconds. "-- --:--
--"(when the first time setting) or the current time appears on the
display.
2. Press the PROGRAM/CLOCK button again. After "SET CLOCK"
appears on the display, the time system appears. Press the f or
e button to select "24HR".
3. Press the PROGRAM/CLOCK button. The hours display blinks.
4. Press the f or e button to set the "hours".
1465AUEnglish.indd 1465AUEnglish.indd 4 4
2.
Two R03/AAA batteries (not supplied)

ADJUSTING THE CLOCK

Remote control range

The buttons on the remote control perform similar functions to similarly
marked buttons on the front panel.
Remote sensor
Within approx. 7 meters
5. Press the PROGRAM/CLOCK button. The minutes display blinks.
6. Press the f or e button to set the "minutes".
7. Press the PROGRAM/CLOCK button to complete the setting, the
original function returns.
- The time can be set accurately by pressing the PROGRAM/
CLOCK button when a time signal is heard.
- To display the clock during operations, press the PROGRAM/
CLOCK button at least 2 seconds. After a few seconds, the original
display returns.
- If a power failure occurs or the mains lead is disconnected, the clock
display blinks. Reset the time again.
4
2008-7-28 2008-7-28 10:00:18 10:00:18