Table of Contents
Advertisement
The manufacturer recommends that you properly install the Portability Kit when using your generator. Installing the Portability Kit is not required
for the GEN7000LP to operate, but is included with the generator purchase.
Figure 1
1. Locate the handle-mounting bracket on the generator frame. (Located on the top right side when looking at the control panel of the generator,
Figure 1). Attached the handle by placing the handle around the outside of the handle-mounting bracket, and aligning the bottom set of holes. Insert
a bolt (M8*50) through home on the frame and the handle-mounting bracket, and secure with a nut (M8) and washer.
Insert the bolt pin (M8, which links with cable) into upper hole on the frame when the handle when moving the generator (Figure 2). To lower the
handle remove the pin, lower the handle, and replace the bolt pin (Figure 3).
(φ27*φ16.5*2) and pin
Figure 5
Install the stabilizing bar (Figure 6) by inserting the bolts (M8x20) through the feet on the stabilizing bar and the generator frame. Tighten the nut (M8)
onto bolt. (Figure 7).
Figure 8
GEN7000LP 7000 Surge Watt / 6000 Running Watt Portable LP Electric Start Generator Manual
PORTABILITY KIT INSTALLATION
Figure 2
Install the wheel axle into frame (Figure 4), fix with a washer
(φ3.2*40). Tighten and secure both wheels. (Figure 5)
BATTERY TRAY INSTALLATION
A battery must be installed before the electric start feature can be used. Disconnect all electrical loads from
this generator before installing/changing the battery. First, mount the battery case in the area located next to
the starter. Insert the bolts (M6x12) through the frame and tighten the balance cover with the bolt (M6x12)
after setting the battery in place. (Figure 8.) Install the battery by using the two cables (one red and the other
black) that are attached to the engine. Attach the red/positive cable to the positive terminal on the battery.
Attach the black /negative cable to the negative terminal on the battery. Slide the battery into the battery case.
Use the enclosed rubber strap to secure the battery in place.
Figure 3
Figure 6
Figure 7
27
Advertisement
Table of Contents
