Step 2 - Connect Fuel - Buffalo GEN7000LP Instruction Manual

Step 2 – Connect Fuel
Sulfur, water, dust, etc. are harmful for engine. If the gas supply source (LPG) contains these harmful elements, user must use filter to remove sulfur,
water etc. and clean gas. Otherwise, the engine service lifetime will be shortened.
Connect Propane Gas Supply Source
Step 1: Keep gas supply source closed.
Step 2: Attach one end of Regulator Hose to propane tank, and attach the opposite end of
Regulator Hose kit to fuel line.
Make sure the LPG cylinder is vertical and securely positioned.
Pre-Operation Check List
Step 1 Check that the gas supply source is in good condition. Check that the gas inlet connection is tightly fixed and not leaking.
Step 2 CHOKE VALVE GRIP is at CHOKE (CLOSE) position. The generator may be hard to start if CHOKE VALVE GRIP is at RUN
(OPEN) position.
Step 3 Check if engine oil is full.
Step 4 Make sure GROUND TERMINAL is properly grounded.
Step 5 AC OUTPUT no load connected.
Disconnect all electrical loads from the generator set before starting the engine. The generator may be hard to start if a load is connected.
Step 6 DC OUTPUT no load connected.
GEN7000LP 7000 Surge Watt / 6000 Running Watt Portable LP Electric Start Generator Manual 13