Reliable MSK-8900M Instruction Manual page 7

G
10~12 10~12
F
E
D
C
B
¡« ¡«
A
- b
- a
6. Connecting pedal with lever of clutch motor (Fig.7)
7 7
(1) The optimum tilt angle of pedal A against floor
is approx.20 ~30 .
(2) Adjust the clutch of motor E to make the rod B
and the clutch lever C run in one line.
(3) When runing, the machine balance wheel G
should rotate counter - clockwise observed form
opposite side of the balance wheel, the motor D
rotates in the same direction. The rotation of motor
can be reversed by reversing the plug of power ( turn
over 180 )
(4) Adjust the tension of V-belt F by moving the
motor upward or downward. The proper tension of
V-belt is a slack of 10~12mm when the V-belt is
depressed by forefinger.
7. Installing the bobbin winder (Fig.8)
8 8
(1) Press the winding controlling lever
utmost position;
(2) Install the winder parallel with the belt hole in
the table, be sure that the belt
5mm by winder pulley
(3) Fix the winder by two wooden screw
(4) When the lever
be sure that the clearance between winder pulley
and belt
8. Installing the belt guard (Fig.9)
9a 9a
(1) Install the three screws
casting, please don't tighten the screws too tight.
- c
;
restores its original position,
is 8mm.
to its
can be pressed to
;
on the machine