Reliable MSK-8900M Instruction Manual page 15

<-3>0.8mm <-3>0.8mm
<-5>1.2mm <-5>1.2mm
30 30
plate is 0.8mm. ( For MSK-8900M ) or 1.2 mm ( for
MSK-8900H)
highest position;
supporter
31 31
the standard angle is that the mark on the shaft
inosculates the ones on the feed dog supporter
highest position;
range of 90 shown in the Fig.31 upon the standard
position
Standarel
Front decline
as Fig B shown;
Front raise
change, so please adjust the height of feed dog again.
32 32
the second mark a on the needle bar
with the bottom of needle bar bushing
4. Adjust the height of feed dog (Fig. 30)
The highest height of feed dog
(1) Turn the hand wheel to lift the feed dog to its
(2) Loosen the screw
(3) Turn the crank
;
(4) Tighten the screw
5. Adjust the angle of feed dog (Fig. 31)
While the feed dog
(1) Turn the hand wheel to lift the feed dog to its
(2) Loosen the screw
(3) Loosen the shaft
If the materials puckering, adjust the feed dog
as Fig A shown;
If the materials slippery, adjust the feed dog
(4) Tighten the screw
After adjustment, the height of feed dog will
6. Adjust the height of needle bar (Fig. 32)
When the needle bar
(1) Locate the needle bar
(2) Pull out the rubber plug
(3) Loosen the screw
upward or down ward
(4) Tighten the screw
(5) Inset the rubber plug
against needle
;
and adjust the feed dog
.
is at its highest position,
;
and adjust it within the
.
is at its lowest position,
should align
at its lowest position
and adjust the needle bar