JVC TH-M303 Service Manual page 29

3.4.10 Removing the power transformer
(See Figs.14 and 15)
• Prior to performing the following procedures, remove the am-
plifier assembly and rear panel.
(1) From the top side of the amplifier assembly, disconnect the
wires from the connectors
er board. (See fig.14)
(2) Remove the four screws P attaching the power transform-
er, and take out the power transformer from the amplifier
assembly. (See fig.15)
Reference:
• When attaching the power transformer, attach the screws P
with the barrier. (See fig.15)
• After connect the wires from the connectors
CN151, bundle the wire by the wire clamp. (See Fig.14)
3.4.11 Removing the speaker net
(See Figs.16 and 17)
(1) From side of the speaker main body, insert the tip of the
flat-bladed screwdriver or similar tool into the space be-
tween the speaker main body and speaker net, and lift the
speaker net little by little to remove. (See Fig.16)
Note:
To prevent damaging the speaker net and speaker main
body, insert cushioning plates etc. to the section c and
below the tip of the flat-bladed screwdriver or similar tool.
(2) From right side of the speaker main body, release the eight
joint d, and take out the speaker net from the speaker main
body. (See Fig.17)
CN102 and CN151 on the moth-
CN102
Amplifier assembly
CN102
and
P
Barrier
Speaker net
Speaker main body
Speaker net
Wire clamp
Mother board
Fig.14
P
Power transformer
Fig.15
Chshioning
blate,etc.
Section c
Flat-bladed
screwdriver,etc.
Fig.16
Joint d
Fig.17
(No.MB184)1-29
CN151