Displaying A Video Image - InFocus LP 600 User Manual

Displaying a video image

Remove the lens cap.
Press the Power button on the top of the projector or the remote.
The LED flashes green and the fans start to run. When the lamp comes on,
the startup screen is displayed and the LED is steady green. It can take a
minute for the image to achieve full brightness. The Interactive Display on
the projector indicates the startup status.
? No startup screen? Get help on page 16.
Plug in and turn on the video device.
The video device's image should appear on the projection screen. If it
doesn't, press the Source button on the keypad.
Adjust the height of the projector by pressing the release button to extend
the elevator foot. Rotate the leveling foot, if necessary.
Position the projector the desired distance from the screen, so that the lens is
perpendicular to the screen. See page 44 for a table listing screen sizes and
distances to the screen.
remove lens cap
press Power button
turn on video device
adjust height
elevator
foot
adjust distance
14
release button
rotate
leveling
foot