Toshiba SD-V330SC Service Manual page 44

NOTE
1. In case of the Clamper Ass'y installation, install correctly
as Fig. 3-5-B.
Clamper Plate
Clamper
3-6: TRAVERSE HOLDER/INSULATOR (F)/INSULATOR
(R) (Refer to Fig. 3-6-A)
1. Remove the Traverse Holder.
2. Remove the 2 Insulator (F).
3. Remove the Insulator (R).
Main Chassis Ass'y
Insulator (F)
Traverse Holder
NOTE
1. In case of the Insulator (F) installation, install correctly as
Fig. 3-6-B.
2. In case of the Insulator (R) installation, install correctly as
Fig. 3-6-C.
Insulator (F)
Insulator (R)
DISASSEMBLY INSTRUCTIONS
No gap
Fig. 3-5-B
Insulator (R)
Insulator (F)
Fig. 3-6-A
Traverse Holder
Fig. 3-6-B
Main Chassis Ass'y (Top Side)
Fig. 3-6-C
3-7: SWITCH PCB ASS'Y/MIDDLE GEAR/FEED MOTOR
(Refer to Fig. 3-7-A)
Remove the screw 1.
1.
2. Remove the Switch PCB Ass'y.
Unlock the support 2.
3.
4. Remove the Middle Gear.
Remove the 2 screws 3.
5.
6. Remove the Feed Motor.
7. Remove the Motor Gear.
Switch PCB Ass'y
Main Chassis Ass'y
• Screw Torque: 3.0 ± 0.3kgf•cm (Screw 1)
• Screw Torque: 1.5 ± 0.3kgf•cm (Screw 3)
NOTE
1. In case of the Motor Gear installation, check if the value
of the Fig. 3-7-B is correct.
2. When installing the wire of the Switch PCB Ass'y, install it
correctly as Fig. 3-7-C.
3. After the assembly of the Main Chassis Ass'y, hook the
wire on the Main Chassis Ass'y as shown Fig. 3-7-D.
Motor Gear
Feed Motor
Safety surface for pressing
of the insert.
• Install wire from (1) to (4) in order.
~ FEED MOTOR ~
ORANGE (4)
BLUE (3)
B3-3
1
Middle Gear
3
3
2
Motor Gear
Feed Motor
Fig. 3-7-A
6.0 ± 0.2mm
Fig. 3-7-B
~ SPINDLE MOTOR ~
YELLOW (2)
GREEN (1)
Switch PCB Ass'y
Fig. 3-7-C