Toshiba SD-V330SC Service Manual page 43

3-3: LOADING MOTOR PCB ASS'Y/ LOADING BELT
(Refer to Fig. 3-3-A)
1. Remove the Loading Belt.
Remove the screw 1.
2.
Remove the 2 screws 2.
3.
4. Remove the Loading Motor PCB Ass'y.
5. Remove the Pulley Gear.
Loading Belt
2
2
1
• Screw Torque: 2.5 ± 0.3kgf•cm (Screw 1)
• Screw Torque: 1.0 ± 0.3kgf•cm (Screw 2)
NOTE
1. In case of the Pulley Motor installation, check if the value
of the Fig. 3-3-B is correct.
2. When installing the Loading Motor PCB Ass'y, install it
correctly as Fig. 3-3-C.
3. In case of the Loading Motor PCB Ass'y installation, hook
the wire on the Main Frame Ass'y as shown Fig. 3-3-C.
Pulley Motor
Loading Motor
Safety surface for pressing
of the insert.
Rack Loading
Check Hook Loading Motor PCB Ass'y
DISASSEMBLY INSTRUCTIONS
Main Frame Ass'y
Pulley Gear
Loading Motor PCB Ass'y
Fig. 3-3-A
7.0 ± 0.1mm
Fig. 3-3-B
The Lever should be position
between A and B.
A B
Fig. 3-3-C
3-4: RACK LOADING/MAIN GEAR/PULLEY GEAR
(Refer to Fig. 3-4-A)
Press down the catcher 1 and slide the Rack Loading.
1.
Unlock the support 2 and remove the Pulley Gear.
2.
3. Remove the Main Gear.
Pulley Gear
Main Gear
2
NOTE
1. In case of the Rack Loading installation, do not mesh it to
the Main Gear as shown the Fig. 3-4-B.
Rack Loading
Main Gear
3-5: CLAMPER ASS'Y (Refer to Fig. 3-5-A)
1. Press the Clamper and rotate the Clamper Plate
clockwise, then unlock the 3 supports 1.
2. Remove the Clamper Plate, Clamper Magnet and
Clamper.
Clamper Plate
Clamper Magnet
B3-2
Rack Loading
Main Frame Ass'y
1
Check Hook
Main Frame
1
1
Clamper
1
Fig. 3-4-A
Fig. 3-4-B
Fig. 3-5-A