Removing The Heat Exchanger And The Compressor - Mitsubishi Electric Mr. SLIM PU-1.6VLJA Technical & Service Manual

OPERATING PROCEDURE

3. Removing the heat exchanger and the compressor

NOTE : When removing the panels, move them up and down
to unhook catches.
( 1 ) Remove the rear panel set screws: 2 screws at the
front, 1 screw on the side, and 3 screws at the rear.
(2) Remove the valve bed.
(3) Open the rear panel rearward to remove.
( 4 ) Remove the 4 screws of the right side panel and
remove it.
( 5 ) Remove the 3 screws of the rear guard and remove it.
( 6 ) Remove the 4 screws of the separator support plate
and remove it.
( 7 ) Remove the 2 screws of the motor support and remove
it.
( 8 ) Remove the 5 screws of the valve bed. Lift the valve
bed to unhook the catches on both sides.
( 9 ) Remove the electrical parts box.
(10) Disconnect the connectors of the high-pressure
switch, crankcase heater, shell thermo, and fan motor.
( 11 ) Remove the 2 screws of the separator and remove it.
( 12 ) Remove the 2 screws of the heat exchanger and
remove it.
(13) Detach the welded points of the pipe.
(14) Remove the 3 nuts of the compressor and remove it.
(15) Detach the welded points of the suction pipe and dis-
charge pipe.
PHOTOS
Photo 4
Screws
Photo 5
SUCTION
Muffler
Photo 6
Charge plug
Ball valve
Compressor
Screws
Heat exchanger
Accumulator
15