Table of Contents
Advertisement
2-15: AHC ASS'Y/CYLINDER UNIT ASS'Y
(Refer to Fig. 2-15)
Unlock the support 1 and remove the AHC Ass'y.
1.
Remove the 3 screws 2.
2.
3.
Remove the Cylinder Unit Ass'y.
NOTE
When you install the Cylinder Unit Ass'y, tighten the
screws from (1) to (3) in order while pulling the Ass'y
toward the left front direction.
Cylinder Unit Ass'y
2
(2)
• Screw Torque: 3 ± 0.5kgf•cm
2-16: CAPSTAN DD UNIT (Refer to Fig. 2-16)
1.
Remove the Capstan Belt.
Remove the 3 screws 1.
2.
3.
Remove the Capstan DD Unit.
1
• Screw Torque: 5 ± 0.5kgf•cm
2-17: MIDDLE GEAR/MAIN CAM (Refer to Fig. 2-17-A)
Remove the Polyslider Washer 1, then remove the
1.
Middle Gear.
2.
Remove the E-Ring, then remove the Main Cam, P5
Cam and Pinch Roller Cam.
Remove the Polyslider Washer 2, then remove the
3.
Joint Gear.
DISASSEMBLY INSTRUCTIONS
AHC Ass'y
1
2
(1)
2
(3)
Fig. 2-15
Capstan Belt
Capstan DD Unit
1
1
Fig. 2-16
Main Cam
Pinch Roller Cam
NOTE
When you install the Pinch Roller Cam, P5 Cam and Main
Cam, align each marker. (Refer to Fig. 2-17-B)
Pinch Roller Cam
Check the hole of Main
Chassis can be seen.
2-18: CLUTCH ASS'Y (Refer to Fig. 2-18)
Remove the Polyslider Washer 1.
1.
2.
Remove the Clutch Ass'y, Ring Spring and Coupling
Gear.
Unlock the 2 supports 2 and remove the Clutch Lever.
3.
Clutch Ass'y
Coupling Gear
Clutch Lever
B2-4
1
Middle Gear
E-Ring
2
Joint Gear
P5 Cam
P5 Cam
Main Cam
Marker
1
Ring Spring
2
2
Fig. 2-17-A
Fig. 2-17-B
Fig. 2-18
Advertisement
Table of Contents
