NEC AccuSync LCD71VM Service Manual page 11

Quick Start
–continued
Removing the Base
Note: Always remove the Base when shipping the LCD.
1. Place monitor face down on a non-abrasive
surface (Figure R.1).
2. While using your thumbs, press the bottom tabs
upward to unlock.
3. Press the top tabs down to unlock and pull off the stand.
Connecting a Flexible Arm
This LCD monitor is designed for use with a flexible arm. Please use the attached
screws (4pcs) as shown in the picture when installing.
To meet the safety requirements, the monitor must be mounted to an arm which
guaranties the necessary stability under consideration of the weight of the monitor.
The LCD monitor should only be used with an approved arm (e.g. GS mark).
Specifications
If using other screws, check depth of holes.
4-SCREWS (M4)
(MAX depth: 8.5 mm)
Replace screws
Thickness of Bracket (Arm)
75 mm (LCD51VM)
100 mm (LCD71VM)
75 mm (LCD51VM)
100 mm (LCD71VM)
W W Weight of LCD assembly:
2.6 kg - LCD51VM (MAX)
4.0 kg -LCD71VM (MAX)
6
1-8
2.0~3.2 mm
Tighten all screws.