NTRODUCTION The TSS-FMK4000 allows you to recess a TSS-SAT4000 or TSS-CENTER4000 into the wall. When installed, the speaker will extend beyond the wall approximately 1. " Unpacking the Components Finish unpacking the flush-mount kit and check the contents. If you suspect damage from transit, report it immediately to your dealer.
Attach both of the end brackets to the speaker ends with the 1/4-20 x 3/4" flat-head machine screw, as shown. 1/4-20 x 3/4" Flat-Head Machine Screw End Bracket End Cap Center Screw 1/4-20 x 3/4" Screw 1/4-20 x 3/4" Flat-Head Machine Screw End Bracket TSS-FMK4000...
Page 4
Place the mounting blocks inside the hole at either end. Use two #8 x 1" flat-head wood screws to secure them in place. Mounting Block (4) #8 x 1" Flat-Head Wood Screws TSS-FMK4000 NOTE: The hole for the speaker should be 22-1/2" x 4-3/8. " Mounting Block...
Page 5
(4) #8 x 1-1/8" Pan-Head Wood Screws Step Six Apply the sealing strips to either side of the speaker to cover the remaining openings of the cutout in the drywall. Sealing Strip TSS-FMK4000...
Page 6
Step Seven Remove the paper cover from the gasket on the speaker-facing side of the frame. Place the frame over the in-wall assembly and snap it into place. Remove Paper Cover From Gasket Frame Center Speaker In-Wall Installation TSS-FMK4000...
Page 7
Satellite Installation Exploded View For satellite installation, repeat the steps but cut the hole in a vertical direction, perpendicular to the floor. Satellite Speaker In-Wall Installation TSS-FMK4000...
Page 8
Infinity Systems, 250 Crossways Park Drive, Woodbury, NY 11797 USA 516.674.4INF (USA only) www.infinitysystems.com Infinity is a registered trademark, and Total Solutions is a trademark, of Harman International Industries, Incorporated. Part No. 400-OMINKIT 10/04 Infinity continually strives to update and improve existing products, as well as create new ones.