Loading The Battery - FujiFilm Discovery S1200 Owner's Manual

1
3
8

LOADING THE BATTERY

Your camera uses one 3V lithium battery
CR123A/DL 123A or the equivalent.
To load the battery.
1 Open the battery compartment cover by inserting a small tool into the cover slot.
2 Insert the battery following instructions in the diagram on the inside of the battery cover
paying particular attention to the position of the , and . poles of the battery. The
battery must be inserted the right way or the camera will not operate.
3 When battery is inserted properly, close the battery compartment cover snapping it securely.
∗
Do not apply excessive force when opening the battery cover.
∗
One lithium battery should be sufficient for approximately 200 exposures (based on our
test conditions).
∗
When traveling, take extra batteries to provide power for extra exposures, particularly
important if you visit areas where fresh batteries may be difficult to obtain.
∗
Check the battery capacity symbol before using your camera. (→p.9)
2
∗
After changing batteries, reset the date to assure accurate date/time recording. (→p.10)
∗
Do not load film before insertng the battery into the camera.