Operating The Remote Control - Coby DVD-815\ Operating Instructions Manual

SYSTEM SETUP
Video Setup
Select [Video] in the Setup Menu, and press ENTER to display
Language Video Audio
Press to
TV Shape
select the menu
TV System
item
Video Output
A . Press ENTER
B. Press
Select [TV shape], and press ENTER or
Language Video Audio
TV Shape
TV System
Video Output
19
A . Press ENTER to confirm
[4:3 PS] -Pan and scan refers to pictures where part of pictures is cut
off so it fills the whole screen.
[4:3LB] -Letter Box refers to pictures where black bands appear at the
top and bottom.
[16:9] -The picture fills the screen of a wide-screen (16:9) television.
Note: Not all DVDs offer movies in Full Screen format. If not, the disc will override your
TV Display setting and the movie will be displayed in Letterbox format.
Select [TV system] and press ENTER or
Language Video Audio
TV Shape
TV System
Video Output
A . Press ENTER to confirm
B. Press SETUP to exit the Setup Menu.
[NTSC] -Select if you are using NTSC signal system to match your TV set.
[PAL] -Select if you are using PAL signal system to match your TV set.
[AUTO]- Select if you are using AUTO signal system to match your TV set.
the [Video] sub menu :
More Aud Rating
4:3 PS
NTSC
S-Video
or to set
to return to the Setup Menu
to display the [TV shape] submenu:
More Aud Rating
4:3 PS 4:3 PS
NTSC 4:3 LB
Press to change your selection
S-Video 16:9
B. Press SETUP to exit the Setup Menu
to display the [TV system] sub menu :
More Aud Rating
4:3 PS
NTSC NTSC
Press to change your selection
S-Video PAL
AUTO
OPERATING THE
REMOTE CONTROL
Battery Installation
1. Push down and out on the battery Compart-
ment cover to remove it.
2. Insert the two AAA batteries into the battery " "
compartment of the remote control, making
sure the + and - signs on the batteries and
inside the battery compartment match up.
3. Replace the battery compartment cover.
Notes:
Do not mix batteries from different manu-
facturers, nor old ones with new.
If the remote control will not be used for an
extended period of time, remove the
batteries to prevent damage-causing
corrosion.
Remove dead batteries immediately to
prevent damage-causing corrosion.
If battery leakage occurs, wipe the battery
liquid from the battery compartment, then
replace both batteries.
Always replace both batteries at the same
time, using new, fully charged batteries.
Life expectancy of batteries may vary
depending on amount of use.
Using the Remote Control
Point the remote control at the remote sensor
on the DVD receiver. When the signal is
received from the remote control, the unit will
function accordingly. The remote will operate to
approximately 16' from the remote sensor at an
0
angle of around 30 each direction.
Notes:
Do not direct the remote sensor toward
any light source, such as direct sunlight or
a strong fluorescent light, as it may cause
the unit to not operate correctly.
When other remote controls are used
nearby or when the remote is used near
equipment using infrared rays, interference
may occur.
Placing an object on the remote control
may cause it to inadvertently depress a
button, changing a function and shortening
battery life.
Do not glaze the front of the DVD receiver
with colored glass, as it may cause
interference with normal operation of the
controller.
Make sure there is no barrier between the
remote control and remote sensor, as it
could prevent the unit from receiving the
signal.
Do not spill water or put wet items on the
remote control.
Never disassemble remote control.
BATTERIES
INCORRECT USE OF BATTERIES MAY
CAUSE THEM TO LEAK, CORRODE OR EXP
LODE.
8