Recommended Test Tools - Motorola Professional Radio Service Manual

3-4
• Next, rub the soldering iron tip along the edge of the shield to smooth out any excess sol-
der. Use solder wick and a soldering iron to remove excess solder from the solder pads on
the circuit board.
• Place the circuit board back in the R1070's circuit board holder.
• Place the shield on the circuit board using a pair of tweezers.
• Position the heat-focus head over the shield and lower it to approximately 1/8" (0.3 cm)
above the shield.
• Turn on the heater and wait for the solder to reflow.
• Once complete, turn off the heat, raise the heat-focus head and wait approximately one
minute for the part to cool.
• Remove the circuit board and inspect the repair. No cleaning should be necessary.
3.6

Recommended Test Tools

Table Table 3-1 lists the recommended tools used for maintaining this family of radios. These tools are
also available from Motorola.
Motorola Part Number
RSX4043
6680387A70
R1453A
0180386A78
0180386A82
6684253C72
6680384A98
1010041A86
1080303E45
R1319A (110V)
or R1321A(220V)
R1364A
R1427A
8880309B53
Table 3-1 Recommended Test Tools
Description
Torx Driver
T-6 Torx Bit
Digital readout solder station
Illuminated magnifying glass
with lens attachment.
Anti-static grounding kit
Straight prober
Brush
Solder (RMA type),
63/37, 0.5mm diameter
1 lb. spool
SMD tool kit (included with
R1319A)
ChipMaster Surface Mount
Rework Station
Digital Heated Tweezer Sys-
tem
Board Preheater
Rework Equipment Catalog
Application
Tighten and remove chassis screws.
Removable Torx driver bit.
Digitally controlled soldering iron.
Used during all radio assembly and disassembly pro-
cedures.
Removal and assembly of surface-mounted inte-
grated circuits and shields includes 5 nozzels.
Chip component removal.
Reduces heatsink on multi level boards.
Contains application notes, procedures and technical
rework equipment.
Recommended Test Tools