Operation - Makita BUC250 Instruction Manual

1
011229
CAUTION:
Before using battery adapter, read all instructions
•
on tools using battery.
When charging a battery cartridge, first remove it
•
from the battery adapter and then charge it. It is not
allowed to charge the battery cartridge while using
battery adapter.
Installing or removing battery adapter
Always switch off the tool before insertion or
•
removal of the battery adapter.
To remove the battery adapter, withdraw it from the
•
tool while sliding the button on the adapter.
To insert the battery adapter, align the tongue on
•
the battery adapter with the groove in the housing
and slip it into place. Always insert it all the way
until it locks in place with a little click. If you can see
the red part on the upper side of the button, it is not
locked completely. Insert it fully until the red part
cannot be seen. If not, it may accidentally fall out of
the tool, causing injury to you or someone around
you.
Do not use force when inserting the battery adapter.
•
If the adapter does not slide in easily, it is not being
inserted correctly.
The way of removing or installing a battery
•
cartridge from or on the battery adapter is the same
as that of removing or installing it from or on the
tools.
Press down the hook securely as far as it will go
•
when the battery adapter is hooked on the waist
belt and similar objects.
Arm cord hook (Accessory)
CAUTION:
Do not attach the holder of arm cord hook to other
•
than the extension cord. Failure to do so may cause
an accident or personal injury.
Using the arm cord hook helps to minimize a risk of
cutting off the extension cord unexpectedly caused by
the loose extension cord.
1. Hook
2. Belt
2
1. Arm cord hook band
2. Holder
3. Extension cord (Batery adapter)
4. Adapter (Battery adapter)
011585
Attach firmly the arm cord hook band placing around your
arm and pass the extension cord through the holder. The
length of the arm cord hook band is adjustable.
NOTE:
Do not pass the extension cord through the band.
•
Do not force the opening of the holder. Failure to do
•
so may cause deflection and damage to it.

OPERATION

Lubrication
1
2
010920
Saw chain is automatically lubricated when the tool is in
operation.
Check the amount of remaining oil in the oil tank through
the oil inspection window.
To refill the tank, remove the cap from the oil tank
opening. The oil tank capacity is 85 ml.
After refilling the tank, always screw the provided oil tank
cap on the chain saw.
CAUTION:
When filling the chain saw with chain oil for the first
•
time, or refilling the tank after it has been
11
1
2
4
3
1. Oil tank cap
4
2. Oil tank opening
3. Oil inspection
window ( for
refilling the tank
with oil)
3
4. Oil inspection
window