Diagrams; Circuit Boards Location; Printed Wiring Boards And Schematic Diagrams - Sony TRINITRON KV-29SL40T Service Manual

6-2.

Circuit Boards Location

C
(KV-29SL40T/29XL40T)
CV
(KV-29VL40T)
6-3. Printed Wiring Boards and Schematic

Diagrams

Note:
• All capacitors are in µF unless otherwise noted.
pF: µµF 50V or less are not indicated except
for electrolytic and tantalums.
• All electrolytics are 50V unless otherwise specified
• Indication of resistance, which does not have one for
rating electrical power, is as follows:
Pitch: 5mm
Rating electrical power 1/4W
• All resistors are in ohms.
KΩ=1000Ω, MΩ=1000KΩ
• f nonflammable resistor.
• ∆ : internal component.
• p: panel designation and adjustment for repair.
• All variable and adjustable resistors have charac-
teristic curve B, unless otherwise noted.
• The components identified by
been carefully factory-selected for each set in order to
satisfy regulations regarding X-ray radiation. Should
replacement be required, replace only with the value
originally used.
• When replacing components identified by
necessary adjustments indicated. If results do not
meet the specified value, change the component
[
identified by and repeat the adjustment until the
specified value is achieved.
(Refer to R584 on page 28 and 29).
• When replacing parts in the table below be sure to
perform the related adjustment.
HV
(KV-29VL40T)
E
]
in this manual have
]
make the
Part replaced (])
IC301,IC521,IC603, DY, D573, D574
C505, C507, C508, C509, C511,
C515, C520, C572, C573, C574,
C575, L591, L501, R582, R583,
R585, R586, R578, R579, T504 (FBT)
IC603, IC601, R699
• All voltages are in V.
• Voltage is DC with respect to ground unless otherwise
noted.
Readings are taken with a 10MΩ digital multimeter.
•
• Readings are taken with a color-bar signal input.
• Voltage variations may be noted due to normal produc-
tion tolerance.
• Circled numbers are waveform references.
• : B + Line
• : B - Line
- - - - -
m
• : signal path
Reference Information
RESISTOR : RN
: RC
: FPRD
: FUSE
: RW
: RS
: RB
:
COIL : LF-8L
CAPACITOR : TA
: PS
: PP
: PT
: MPS
: MPP
: ALB
: ALT
: ALR
Note: The symbol G display is on the component side.
The components identified by shading and mark ¡ ¡ ¡ ¡ ¡ are
critical for safety. Replace only with part number
specified.
The symbol G indicates fast operating fuse.
Replace only with fuse of same rating as marked.
— 38 —
Adjustment ([)
HV HOLD-DOWN
(R584)
B+ VOLTAGE
CONFIRMATION
METAL FILM
SOLID
NON FLAMMABLE CARBON
NON FLAMMABLE FUSIBLE
NON FLAMMABLE WIREWOUND
NON FLAMMABLE METAL OXIDE
NON FLAMMABLE CEMENT
ADJUSTMENT RESISTOR
MICRO INDUCTOR
TANTALUM
STYROL
POLYPROPYLENE
MYLAR
METALIZED POLYESTER
METALIZED POLYPROPYLENE
BIPOLAR
HIGH TEMPERATURE
HIGH RIPPLE