KV-29SL40T / 29VL40T / 29XL40T
5-1. ELECTRICAL ADJUSTMENT BY REMOTE COMMANDER
Use Remote Commander (RM-Y165) to perform circuit
adjustments on this model.
NOTE : Test Equipment Required:
1. Pattern Generator
2. Frequency Counter
3. Digital Multimeter
4. Audio OSC
(1) Method of Setting the Service
Adjustment Mode
SERVICE MODE PROCEDURE
1. Standby mode. (Power off)
2.
Remote Commander. (Press each button within a
second.)
SERVICE ADJUSTMENT MODE IN
Disp.
(Item)
SERVICE
SYS
3. The CRT displays the item being adjusted.
4. Press
or
on the Remote Commander to select the item.
5. Press
or
on the Remote Commander to change the
data.
6. Press
then
SERVICE ADJUSTMENT MODE MEMORY
SERVICE
WRITE
CIRCUIT ADJUSTMENTS
on the
Item
data
0
to write into memory.
Green
Red
SECTION 5
7. Press
then
initialize.
SERVICE
RESET
8. Turn set off and on to exit.
(2) Memory Write Confirmation Method
1. After adjustment, pull out the plug from the AC outlet,
then replace the plug in the AC outlet again.
2. Turn the power switch ON and set to service mode.
3. Call the adjusted items again to confirm they were adjusted.
(3) Adjust Buttons and Indicator
— 30 —
on the Remote Commander to
Carry out step 7 when adjusting
IDs 0 to 4 and when replacing
and adjusting IC003.
RM-Y165