Table of Contents
Advertisement
KV-29SL40T / 29VL40T / 29XL40T
2-5-2. PICTURE TUBE REMOVAL (KV-29VL40T)
WARNING
BEFORE REMOVING ANODE CAP
H.V. remains in the CRT even after
the power is disconnected.
Discharge CRT before attempting to
remove the anode cap to avoid elec-
trical shock. Short between anode
and CRT coating earth ground strap.
ANODE-CAP REMOVAL
WARNING: High voltage remains in the CRT even after the power is disconnected. To avoid electrical shock, discharge CRT before
attempting to remove the anode cap. Short between anode and coated earth ground strap of CRT.
NOTE:
After removing the anode, short circuit the anode of the picture tube and the anode cap to either the metal chassis, CRT shield
or carbon painted on the CRT.
REMOVAL PROCEDURES
a
Turn up one side of the rubber cap in
the direction indicated by arrow a.
HOW TO HANDLE AN ANODE-CAP
Do not use sharp objects which may cause damage to the
surface of the anode-cap.
Do not squeeze the rubber covering too hard to avoid damag-
ing the anode-cap. A material fitting called a shatter-hook
terminal is built into the rubber.
Do not force turn the foot of the rubber cover. This may cause
the shatter-hook terminal to protrude and damage the rubber.
Degaussing coil
CV board
Deflection yoke
Four screws
(Tapping screw 7)
Anode cap
Coating earth
ground strap
b
Use your thumb to pull the rubber cap
firmly in the direction indicated by
arrow b.
Two DGC holders (M)
Picture tube
3 When one side of the rubber cap sepa-
— 24 —
E board
A board
HV board
Tension spring (B)
Cushion
c
Anode Button
rates from the anode button, the anode-
cap can be removed by turning the rub-
ber cap and pulling it in the direction of
arrow c.
Advertisement
Table of Contents
