-----
~-
C& T International Inc.
46 Whelan Road
East Rutherford, NJ 07073
MODEL #740 VICK CRIB
ASSEMBLY INSTRUCTIONS
•
INSTRUCCIONES DE ASSEMBLA.JE
CAUTION
Any mattress used in this crib must be at least 271/4 inches (69cm) by 51 5/8 (131cm) with a
thickness not to exceed 6 inches (15cm).
This crib conforms to all applicable regulations promulgated by the consumer product safety commission.
Upon completion of assembly, be sure all screws, bolts and fastening devices have been securely tightened.
Afrequent check should be made of all screws, bolts and fastening devices and tightened if needed.
A
W'
ARN
I
N
G·
Failwe t9 follow these warnings and assembly instructions could result in
~
1-\
• Senous Injury or death.
-Read all instructions before assembling crib. KEEP INSTRUCTIONS FOR FUTURE USE.
-Before each usage or a§Sembly, inspect crib for damage hardware, loose joints, missing parts or sharp edges.
DO NOT use crib if any parts are missing or broken. Ask your dealer or write to C&T International for replacement parts
and
instnictionall~erafure
if needed. DO NOT substitute parts.
-After raising side, make sure latches are secure.
-When child is able to climb out or reaches the height of 35 in. (90cm), the crib shall no longer be used.
-DO NOT place crib near window where cords from blinds or drapes may strangle achild.
-Strings can cause strangulationIDo not place ttems with astring around achild's neck, such as hood strings or pacifier
cords. Do not suspend strings over acrib or attach strings to toys.
.
-If refinishing, use a non-toxic finish specified for children's produtcs.
-DO NOT leave child in crib with side lowered. Be sure side is in raised and locked position whenever child is in crib.
-When
c~i1d
is able to pull to standing
positio~, s~t
mattress to lowest position and remove bumper pads, large toys and,
other objects that could serve as steps for climbing out.
.
-Never use plastic shipping bags or other plastic film as mattress covers because they can cause suffocation.
-DO NOT use awater mattress with this crib.
-The product including side rails must be fully erected prior to use.
-Check fastemers periodically, do not over tighten. This may cause distortion or breakage.
-Keep wall decorations, especially those with strings, completely out of achild's reach.
-DO NOT tie pacifiers, necklaces, or any other items around achild's neck or on crib parts. This could cause strangulation
-Use acrib as acrib, not as aplay yard. Remember that acrib is not asubstttute for aparenfs supervision.
-Parents should ensure asafe environment for their child by checking the crib regularly before placing tbe child in the
product. Please make sure that every component is
prope~y
and securely in place..
For cribs equipped with teething rails: - Replace teething rail if damaged or loose.
11.
Never leave infant alone in crib with sides down
DO NOT leave child alone in crib with side lowered. Be sure side is in
raised and locked position whenever child is in crib.
If you find that your furniture has a missing or damage part, contact your local C& T dealer.
Need help?
Do you have a question about the 740 VICK CRIB and is the answer not in the manual?
Questions and answers
Directions say it converts into a full size bed but it does not. Slats provided don’t fit either.
The C&T International 740 VICK CRIB can convert into a full-size bed, but a separate Full Bed kit is required for this conversion. The provided slats do not fit because they are not designed for the full-size bed configuration. The crib's original components are meant for crib and toddler bed use, and additional parts are necessary for proper assembly as a full bed.
This answer is automatically generated