Summary of Contents for C&T International Sorelle Modesto
Page 1
By Sorelle - A Division of C & T International, Inc. 46 Whelan Road, East Rutherford, N.J.07073 U.S.A. Tel, 201-531-1919 Fax, 201- 531-1920 Website: www.sorellefurniture.com Modesto/Monterey flat top crib Assembly Instruction Important Information: BEFORE assembling crib. Read all instructions KEEP INSTRUTIONS FOR FUTURE USE. Made in Thailand...
Page 2
SORELLE Crib Warnings WARNING *Infants can suffocate on soft bedding. Never add a pillow or comforter. Never place additional padding under an infant. *Failure to follow these warnings and the assembly instructions could result in serious injury or death. DO NOT use this crib if you cannot exactly follow the accompanying instructions. *To reduce the risk of SIDS, pediatricians recommend healthy infants be placed on their backs to sleep, unless otherwise advised by your physician.
Sorelle NOTES ON ASSEMBLY: -During the assembly process whenever using screws or bolts, check each by placing the screw/bolt on the diagram of the item which is drawn actual size and design. Be sure to use the proper size and shape specified in the instructions.
Page 4
SORELLE (E) Mattress Support (A) Left End (1 pcs) (1 pcs) (F) Left Back Post (B) Right End ( 1 pcs) (1 pcs) (G) Right Back Post ( 1 pcs) (C) Foot Board (J) Crib Top Back Rail ( 1 pcs) (D) Mattress Support Bar ( 1 pcs) (H) Headboard Panel...
Page 5
SORELLE Step 2 Attach (J) Headboard Top Rail to Left Headboard Post (F) and Right Headboard Post (G) to using (2 pcs) Bolts with 2 pcs Half moon washer(d) as shown. Figure 2 Use 6 pcs Bolts (c) with 6 pcs Washers(f) & 6pcs Lock Washers (g) to attach Step 3 Left End(A) &...
Page 6
SORELLE Crib Assembly Lower Level Step 4 Center Level Attach the Mattress Support Use 4 pcs Bolts (a) with 4pcs Lock Washers (g)to attach Left End(A) and Right End (B) Higher Level Figure 4 Step 5 Use 6 pcs Bolt (c) & 6 pcs Washers(f) & 6 pcs Lock Washers(g) attach Foot Board(C) to Left End (A) &...
Page 7
SORELLE FINALLY CHECK • PRIOR TO USING THE CRIB, ENSURE ALL BOLTS ARE TIGHTENED. DO NOT OVER TIGHTEN. • ENSURE THAT THE MATTRESS IS THE RECOMMENDED SIZE. • ENSURE THE MATTRESS BASE IS LOCATED AT THE CORRECT LEVEL TO SUIT THE CHILD. •...