Installation; Installation Option; Tools And Materials Required; Parts Supplied - GE ZMC1095 Installation Instructions Manual

These built-in ovens can be inset into the

Installation

cabinetry. In this installation the microwave is
Options
recessed and flush with the front surface of
the cabinet.
A shadow box affect can be achieved by
installing a rail at the top and bottom of the
microwave to fill the cutout height. In this
Inset/Recessed Installation
• Cut 4 stopper strips, 13/16" square to frame
1
• Lift and hold the oven up to the opening.
Step
• Hold the oven at the 45° angle and plug in
• Carefully, slide the oven into the cabinet.
Slide the
• Check to be sure that power cord is not
Microwave
into Cutout
26-3/4"
4-1/4"
11"
18-5/8"
13/16" x 13/16" Sq.
Stopper Strip 4 sides
the opening, install the strips 13/16" from
the front edge of the opening. Oven overlap
will cover all 4 stopper strips.

Tools and Materials required:

• #2, Phillips screwdriver
• 2 each #8x1" - Round head
• Hand held drill motor
• High speed drill bit, 1/8"
• 3/8", slothead screwdriver
diameter
the power cord.
trapped under the bottom or the sides of the
oven.
Installation
installation, exposed inside surfaces of the
cabinet should be finished to match the
cabinet surface.
• In both a recessed and shadow box
1"
26-3/4"
Shadow Box Installation
• Cut top and bottom rail to fit the width of
the opening. Cut the height of the rails to fit
the cutout height. Use cleats to secure the
rails to the inside walls of the cabinets.

Parts supplied:

• 2 mounting screws
• 4 extra side trim screws
wood screws
• 2 side trim pieces
Built-In Microwave/Convection Oven
installation, the floor of the cutout must be
level and even with the bottom edge of the
cutout. Use runners inside the opening to
raise the floor to matching height.
Top
Rail
Bottom
Rail
4