Using The Oven Control - Amana ACS4250 Owner's Manual

OVEN
LIGHT
Setting Electronic Clock
The 12 hour clock does not display
connected or restored, display flashes until pad is pressed.
1. Press CLOCK pad.
• TIME displays in lower left corner
2. Press MORE or LESS pads until correct time-
of-day displays.
3. Press CLOCK pad to set time.
• If CLOCK pad is not pressed, approximately
60 seconds after last entry, TIME disappears
and clock is set
Setting Minute Timer
The timer is a timer only. Electronic timer does not control bake, broil, or
self-clean function. Timer can be set from 5 seconds to 9 hours and 50
minutes.
1. Press TIMER pad.
• TIMER displays in lower left corner
2. Press MORE or LESS pads until desired
amount of time displays.
• Timer begins counting down automatically
after time is entered.
3. Press and hold TIMER pad to cancel timer
signal.
• After time elapses, timer beeps 3 times
then approximately once every 6 to 8
seconds until TIMER pad is pressed.
Resetting and Canceling Timer
To reset the time when remaining time is displayed press MORE or LESS
pads until desired time displays. To cancel timer when remaining time is
displayed or when signal is beeping, press TIMER ON/OFF pad and hold for
approximately 5 seconds.

Using the Oven Control

8888
DELAY
HR
OVEN ON
CLEAN
STOP
TIMER
,
or military time. When power is
AM PM
11
888
BAKE BROIL
O
N
CLEAN LOCK
Flashing Display
When power is connected or
interrupted, oven display flashes.
Press CLOCK to clear display. Clock
may need to be reset.
Making the Numbers
Increase at a Faster Rate
Time increases in larger increments
the longer or
+
Timer Signal
When time elapses, timer
beeps 3 times then approximately
once every 6-8 seconds until
TIMER ON/OFF pad is pressed.
End-of-Cycle Signal
When a timed cooking cycle is
complete, three long signals
sound. End of cycle signal
continues to sound until
OVEN CANCEL pad is pushed.
pad is held.