Connect To Your Pc; Connect To Pc - Napa PA-11 Operating Instructions Manual

8

Connect to PC

You need not switch off your computer when you
connect the unit to the PC since USB is Plug-and-Play.
Connection
(1) The battery must be in the player.
(2) Position the PC so that its USB ports can be easily
accessed.
(Note : The USB port(s) may be found on the front
panel or elsewhere instead of the back panel. Refer
to your PC dealer for support if necessary. )
(3) Plug the flat USB connector of the bundled USB
cable to the PC.
(4) Plug the square connector of the USB cable to the
unit.
(5) Press Play button to turn the unit on.
(6) USB IDLE will appear on LCD of the unit.
For Windows Users
Install and Update
(7) System will detect the new hardware exists in your
system and install each of them automatically.
(8) Upon the driver installation is completed, run the
Play Update utility that is now available in the start
menu of your Windows system.
Verify Correct Installation of the unit
(9) When the Player Update is completed, the player is
ready to use. If you wish to check that whether MP3
Flash Player has properly installed on your system,
double-click on My Computer icon on the desktop
of your Windows.
(10) You will observe your MP3 Flash Player shows up as
Removable Disk (F:) and (G:) drives in Windows.
(11) Removable Disk (F:) implies the built-in flash
memory of the MP3 Flash Player.
Removable Disk (G:) drive implies the SmartMedia
Card (if any) inserted into the MP3 Flash Player. In
case if SmartMedia Card is not present in the player,
Removable Disk (G:) will not be accessible.