Table of Contents
Advertisement
3
Chapter
You need not switch off your computer when you connect the player to the PC
since USB is Plug-and-Play. Before USB connecting with computer disconnect the
earphone from the player.
Setup Connection
(1) Position the PC so that its USB ports can be easily accessed.
(Note: The USB port(s) on you PC may be found on the front panel instead of
the back panel. Contact your system vendor if need)
(2) Remove the USB cap of the player;
(3) Connect the built-in B type USB connector to the USB port of PC;
(4) The player LED lights up in Red. It is indicates that the USB connection is good.
Connect to PC
3-1 For Windows
Step 10. Once you have plugged in the player to your PC, system detects New
hardware and starts to install the drivers automatically. Wait for system
finish the installation.
Step 11. When finished, you can click Start -> Program -> NAPA PA22 MP3
Player -> Player Update. If current firmware version is lower than
Update firmware version, please click on Start button. Otherwise, you
need not to update. Click on Close button to exit.
Step 12. The driver installation has finished.
Step 13. Double-click on My Computer on desktop. It shall be observed that one
new Removable Disk appears in the My Computer window. It is the
memory built-in the player.
Step 14. Now you can download your WMA/MP3 music to the player by copying
the files to the new Removable Disk.
User's Manual/English/ Version 1.0 / PA22
Connect to PC
Index
Page6
Advertisement
Table of Contents
