Driven Chain; Driven Chain’s Regulation - Generic Trigger X User Manual

Driven chain

The life-span of driving chain depend on the proper lubricate and adjustment. Improper maintenance may
result in earlier abrasion of driving chain and chain wheel.
Driven chain's regulation
When you drive 1000 kilometers everytime,take the following step to adjust the laxity of the driving chain in
order to maintain the vertical of driving chain between 10mm and 20mm.According to your driving
condition, the driving chain needs adjust frequently.
WARNING：
This suggestion is maximal time alternation; you should check and adjust chain before every time you drive.
Too much looseness can result in accident of taking off chain or heavy damage of the engine.
Take following step to adjust chain:
1. stand your motorcycle
2. To loosen back axes nut.
3. To loosen lock nut.
4. to regulate screw towards left or right in order to adjust chain's laxity, you must keep line between
front wheel and rear wheel when you regulate chain. In order to help you to finishing this regulation
process, in swing arm and reference mark on each chain regulator, they can aim at each other or
as contrast from end to end.
After adjust chain endurance between 10-20mm, refax nuts of rear shaft and execute final examination.
ATTENTION: If necessary, check the abrasion of two chain wheel before replace with new chain.
When execute when execute periodical checking, please check below steps:
(1) Loosed pin
(2) Broken idler wheel
(3) Dry or rusty chain burl
(4) Tweaked or blocked chain burl
(5) Excessive dandify
(6) Adjust chain
WARNING
Chain's nip is located in the openings; please fit it with reverse direction.
If above defects appeared which cause may dandify to the chain wheel.
Must check below:
(1) Excessive worn gear.
(2) Snapped or damaged gear.
(3) Loosed fix up nuts of chain wheel.
Lubricate of drive chain