HP ExpressCard Hardware Setup Manual page 33

Configuring external speakers
If you connected your audio receiver after running the Setup
Wizard for the first time, you may need to reconfigure settings.
✎
If you have not yet run the Setup Wizard, you do not need to
perform the following procedure. The Setup Wizard will guide
you through all the configuration steps required for your
connection.
You can use either Windows Media Center or QuickPlay to
configure external speakers (either directly connected to
your computer or to an audio receiver that is connected to your
computer).
To configure the external speakers using Windows Media Center,
follow these steps:
1. Open Windows Media Center:
❏
– or –
❏
2. Select Tasks > Settings > General > Windows Media
Center Setup > Set Up Your Speakers.
3. Follow the on-screen instructions.
– or –
To configure the external speakers using QuickPlay, follow these
steps:
1. Open QuickPlay:
❏
– or –
❏
Hardware Setup
Press the Start button on your remote.
From your Windows desktop, select Start > Windows
Media Center.
Press the QuickPlay button on your remote.
From your Windows desktop, select Start > All
Programs > QuickPlay.
Advanced connections
4–11