Hardware Installation; Using The Mobile Gateway™ Finder Utility - Inetcam Mobile Gateway User Manual

All of these items may be changed by opening a browser on a PC and going to the IP address of
the Mobile Gateway™ video server by entering that address in the browser address bar (e.g.
http://192.168.0.2.)

Hardware installation

For best results, hardware connections should be initiated in the following order:
1. Connect the network cable to the Mobile Gateway™ video server NIC.
2. Plug the cameras into the Mobile Gateway™ video server.
3. Connect the power cord to the Mobile Gateway™ video server.
4. Power on the Mobile Gateway™ video server.
5. Run the Mobile Gateway™ video server Finder utility to configure the Mobile Gateway™
video server.
Using The Mobile Gateway™ Finder Utility
Mobile Gateway™ configures in much the same way as a "standard" analog to IP video server:
use the Mobile Gateway™ Finder utility to locate servers and configure them remotely on the
network.
To use the Mobile Gateway™ Finder utility, insert the CD into a CD-ROM. Browse to the CD
Drive on the PC and launch Finder.exe. The utility will launch:
Draft version 1.7
Inetcam® and iMViewer™ are the property of Inetcam, Inc.
4