Safety Guidelines - Definitions; Functional Description - Black & Decker MS600B Instruction Manual

90518305 02 MS600 ZONE MOUSE
and other construction activities. Wear protective clothing and wash exposed
areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the
skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disperse dust, which may cause
serious and permanent respiratory or other injury. Always use NIOSH/OSHA
approved respiratory protection appropriate for the dust exposure. Direct particles
away from face and body.
WARNING: ALWAYS use safety glasses. Everyday eye glasses are NOT safety
glasses. Also use face or dust mask if cutting operation is dusty. ALWAYS WEAR
CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3)
• ANSI S12.6 (S3.19) hearing protection
• NIOSH/OSHA/MSHA respiratory protection

SAFETY GUIDELINES - DEFINITIONS

It is important for you to read and understand this manual.
The information it contains relates to protecting YOUR SAFETY and PREVENTING
PROBLEMS. The symbols below are used to help you recognize this information.
DANGER:
Indicates an imminently hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING:
Indicates a potentially hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION:
Indicates a potentially hazardous situation which, if not avoided, may
result in minor or moderate injury.
CAUTION:
Used without the safety alert symbol indicates a potentially hazardous
situation which, if not avoided, may result in property damage.
The label on your tool may include the following symbols.
Symbols
V ..........................volts
Hz ........................hertz
min ........................minutes
......................direct current
.......................... Class II Construction
........................safety alert symbol

FUNCTIONAL DESCRIPTION

A. Contour sanding attachments
B. Contour sandpaper
C. Sandpaper tips
D. Sandpaper
E. Finger sanding attachment sandpaper
F. Finger sanding attachment
G. Zone INDICATOR ("U" display)
H. "OFF" Switch
I. "ON" Switch
3/26/08 9:20 AM Page 4
A..........................amperes
W ........................watts
n o ........................no load speed
.../min ..................revolutions or
A
G
H
I
4
......................alternating current
........................earthing terminal
reciprocations per minute
F
D
C
B
E